hrithik18k/switch-pcb

relay-build.log

Building 1 file(s)...
Building relay.circuit.tsx...
Generating circuit JSON...
Wrote debug artifact: dist\relay-router\placement-unrouted.png
Autorouting <board#91 /> phase 1/1 start: connections=7, obstacles=23, previous_traces=0, router=tscircuit, solver=AutoroutingPipelineSolver9_PreloadedTraceGraph, cache=miss, cache_id=12cad7cd/ad4f12fc
  connections: net.V5, net.GND, net.GATE, net.COIL, net.IN, net.LINE, net.LOAD
Wrote debug artifact: dist\relay-router\phase-0.input.simple-route.json
  phase 1/1 progress: solver=AutoroutingPipelineSolver9_PreloadedTraceGraph solver_phase=topologyPlanningSolver steps=1 progress=17% iterations_per_second=3856 elapsed=983ms
  phase 1/1 done: routed_traces=11, jumpers=0, errors=0, elapsed=4.4s
Wrote debug artifact: dist\relay-router\phase-0.output.traces.json
Wrote debug artifact: dist\relay-router\phase-0-routed.png
Saved autorouting paths to .tscircuit\autorouting-artifacts\relay-circuit-tsx-0d426fbd52\subcircuit_source_group_0-phase-default-order-0.pcb-trace-paths.json (import this JSON into <autoroutingphase pcbTracePaths={...} />).
Wrote debug artifact: dist\relay-router\board.meta.json
Circuit JSON written to dist\relay\circuit.json
The "Q" prefix is being used with a <chip />, try using it with a <transistor />
The "J" prefix is being used with a <chip />, try using it with a <connector /> or <jumper />
The "J" prefix is being used with a <chip />, try using it with a <connector /> or <jumper />
K1 has no pin with requires_power=true
K1 has no pin with requires_ground=true
All pins on K1 are underspecified (no pinAttributes set)
Q1 has no pin with requires_power=true
Q1 has no pin with requires_ground=true
All pins on Q1 are underspecified (no pinAttributes set)
All pins on J2 are underspecified (no pinAttributes set)
All pins on J3 are underspecified (no pinAttributes set)
No <schematicsheet> was found. Add a <schematicsheet> to define the schematic drawing area.
<pinheader#9 name=".J1" /> is missing a manufacturer part number and could not be resolved to a supplier part. Specify mpn, manufacturerPartNumber, or mfn, provide supplierPartNumbers, or configure a parts engine to select a part. If this part will not be assembled, mark it doNotPlace.
Generating preview images...
[relay] Generating PCB PNG...
[relay] Written pcb.png
[relay] Generating schematic PNG...
[relay] Written schematic.png

Build complete
  Circuits  1 passed
  Options   pcb-png, schematic-png, autorouter-debug, autorouter-dump-srj
  Output    dist

✓ Done
Build exiting with code 0: build finished successfully