hrithik18k/switch-pcb

jlc-relay-placement.log

placement summary: no placement issues

board top-layer utilization:
- occupied: 15.651% (375.625mm^2 of 2400mm^2)
- empty spaces over 5% of board area:
  - 27.487% (659.695mm^2); bounds=(minX=-10.184mm, maxX=25mm, minY=-24mm, maxY=-5.25mm)
  - 22.468% (539.231mm^2); bounds=(minX=-11.946mm, maxX=25mm, minY=9.405mm, maxY=24mm)
  - 9.867% (236.818mm^2); bounds=(minX=-25mm, maxX=-20.066mm, minY=-24mm, maxY=24mm)

board-edge status:
- K1: 15.11mm inside left edge
- J1: 5.666mm inside left edge
- Q1: 7.5mm inside left edge
- D1: 6.715mm inside left edge
- R1: 6.434mm inside left edge
- R2: 11.434mm inside left edge
- J2: 5.9mm inside right edge

placement drc:
Errors: 0
Warnings: 2
- pcb_connector_not_in_accessible_orientation_warning: J1 is inferred to face y- from its cable insertion center because no explicit footprint insertionDirection is defined, but should face x- so the connector is accessible from the board edge. Set insertionDirection on the <footprint> to specify the actual direction in the footprint's unrotated orientation; for example, <footprint insertionDirection="from_above"> for a connector accessed from above the PCB (+Z).
- pcb_connector_not_in_accessible_orientation_warning: J2 is inferred to face x- from its cable insertion center because no explicit footprint insertionDirection is defined, but should face x+ so the connector is accessible from the board edge. Set insertionDirection on the <footprint> to specify the actual direction in the footprint's unrotated orientation; for example, <footprint insertionDirection="from_above"> for a connector accessed from above the PCB (+Z).