hrithik18k/switch-pcb

jlc-esp-pipeline1.log

Building 1 file(s)...
Building index.circuit.tsx...
Generating circuit JSON...
Wrote debug artifact: dist\esp-router\placement-unrouted.png
Autorouting <board#135 /> phase 1/1 start: connections=12, obstacles=66, previous_traces=0, router=tscircuit, version=beta_pipeline1, solver=AutoroutingPipeline1_OriginalUnravel, effort=5x, cache=miss, cache_id=77fc192e/f97652c1
  connections: net.V5, net.GND, net.V3V3, net.EN, net.RST, net.BOOT, net.STRAP2, net.STRAP15, net.RELAY, net.TOUCH, net.TXD, net.RXD
Wrote debug artifact: dist\esp-router\phase-0.input.simple-route.json
  phase 1/1 progress: solver=AutoroutingPipeline1_OriginalUnravel solver_phase=singleLayerNodeMerger steps=1 progress=0% iterations_per_second=5708 elapsed=1.0s
returning the cached section connection terminals
  phase 1/1 progress: solver=AutoroutingPipeline1_OriginalUnravel solver_phase=highDensityRouteSolver steps=35 progress=0% iterations_per_second=3536 elapsed=11.2s
  phase 1/1 done: routed_traces=36, jumpers=0, errors=0, elapsed=11.8s
Wrote debug artifact: dist\esp-router\phase-0.output.traces.json
Wrote debug artifact: dist\esp-router\phase-0-routed.png
Could not save autorouting paths for subcircuit_source_group_0: Routes contain a junction or endpoint that cannot select a unique PCB port
Wrote debug artifact: dist\esp-router\board.meta.json
Circuit JSON written to dist\index\circuit.json
The "J" prefix is being used with a <chip />, try using it with a <connector /> or <jumper />
The "J" prefix is being used with a <chip />, try using it with a <connector /> or <jumper />
The "J" prefix is being used with a <chip />, try using it with a <connector /> or <jumper />
The "J" prefix is being used with a <chip />, try using it with a <connector /> or <jumper />
J1 has no pin with requires_power=true
J1 has no pin with requires_ground=true
All pins on J1 are underspecified (no pinAttributes set)
J2 has no pin with requires_power=true
J2 has no pin with requires_ground=true
All pins on J2 are underspecified (no pinAttributes set)
J3 has no pin with requires_power=true
J3 has no pin with requires_ground=true
All pins on J3 are underspecified (no pinAttributes set)
J4 has no pin with requires_power=true
J4 has no pin with requires_ground=true
All pins on J4 are underspecified (no pinAttributes set)
No <schematicsheet> was found. Add a <schematicsheet> to define the schematic drawing area.
Generating preview images...
[index] Generating PCB PNG...
[index] Written pcb.png
[index] Generating schematic PNG...
[index] Written schematic.png

Build complete
  Circuits  1 passed
  Options   pcb-png, schematic-png, autorouter-debug, autorouter-dump-srj
  Output    dist

✓ Done
Build exiting with code 0: build finished successfully