muse/esp32-eink-display

A 55×46 mm two-layer ESP32-S3 e-paper controller board with USB‑C power/programming, buck regulation, FPC display connector, UC8179-style boost/charge-pump circuitry, ESD protection, controls, and routed passive components.

Version
1.3.4
License
unset
Stars
0

firmware/sdkconfig.muse-eink

# Muse e-paper gadget rev C, onboard ESP32-S3-WROOM-1-N8R8.
# Load after esp32/sdkconfig.defaults; no panel driver changes required.
# SDK reference: facebookincubator/muse-gadget-sdk
# 7e7123e2815d3e7e3c0f2ca330f576290ae6a6a9
# Sources: Espressif ESP32-S3-WROOM-1 datasheet; Good Display GDEY075T7;
# muse-gadget-sdk/esp32/main/epaper_status.c for GPIOs/controller.
CONFIG_IDF_TARGET="esp32s3"
CONFIG_ESP_DEFAULT_CPU_FREQ_MHZ_240=y
CONFIG_HOMEHUB_LED_BACKEND_RETERMINAL_UC8179=y
CONFIG_HOMEHUB_BLE_NAME_SUFFIX="-Eink"
# SW1 is GPIO6, active-low. GPIO3 (an S3 strapping pin) is unused.
CONFIG_HOMEHUB_BUTTON_GPIO=6
CONFIG_HOMEHUB_SHOW_AGENT_NAME=y
CONFIG_ESPTOOLPY_FLASHMODE_DIO=y
CONFIG_ESPTOOLPY_FLASHFREQ_80M=y
CONFIG_ESPTOOLPY_FLASHSIZE_8MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="8MB"
CONFIG_SPIRAM=y
CONFIG_SPIRAM_MODE_OCT=y
CONFIG_SPIRAM_MODE_QUAD=n
CONFIG_SPIRAM_SPEED_80M=y
CONFIG_SPIRAM_IGNORE_NOTFOUND=n
CONFIG_BT_NIMBLE_MEM_ALLOC_MODE_EXTERNAL=y

# Onboard USB-C connects directly to native GPIO19/20 USB Serial/JTAG.
CONFIG_ESP_CONSOLE_USB_SERIAL_JTAG=y
CONFIG_ESP_CONSOLE_UART_DEFAULT=n
CONFIG_ESP_CONSOLE_USB_CDC=n