mohan-bee/disco

index.tsx

PCB

Schematic

import React from "react"

export default  Compoo = () => {
  const cd4017Outputs = [
    "pin3", "pin2", "pin4", "pin7", "pin10", 
    "pin1", "pin5", "pin6", "pin9", "pin11"
  ];

  return (
    <board width="50mm" height="60mm">
      
      <net name="VCC_5V" isPowerNet={true}  />
      <net name="GND" isGroundNet={true}  />

      <chip 
        name="U1" 
        footprint="soic8" 
        pcbX={-10} 
        pcbY={-10} 
        pinLabels={{
          pin1: "GND", pin2: "TRIG", pin3: "OUT", pin4: "RESET",
          pin5: "CTRL", pin6: "THR", pin7: "DIS", pin8: "VCC"
        }}
      />
      
      <chip 
        name="U2" 
        footprint="soic16" 
        pcbX={10} 
        pcbY={-10} 
        pinLabels={{
          pin8: "GND", pin13: "EN", pin14: "CLK", pin15: "RST", pin16: "VCC"
        }}
      />

      <trace from=".U1 > .VCC" to="net.VCC_5V" />
      <trace from=".U1 > .GND" to="net.GND" />
      <trace from=".U2 > .VCC" to="net.VCC_5V" />
      <trace from=".U2 > .GND" to="net.GND" />
      
      <trace from=".U1 > .OUT" to=".U2 > .CLK" />

      <trace from=".U2 > .EN" to="net.GND" />
      <trace from=".U2 > .RST" to="net.GND" />



      {Array.from({ length: 10 }).map((_, i) => {

        const angleRadians = Math.PI - (i * (Math.PI / 9)); 
        const radius = 18; // mm
        
        // Calculate X and Y positions based on the angle
        const x = Math.cos(angleRadians) * radius;
        const y = Math.sin(angleRadians) * radius + 5; 
        
        // Rotate the LEDs so they point outward from the center
        const rotationDegrees = (angleRadians * 180) / Math.PI - 90;

        return (
          <group key={`led-channel-${i}`}>
            

            <led 
              name={`D${i}`} 
              footprint="0805" 
              pcbX={x} 
              pcbY={y} 
              pcbRotation={rotationDegrees} 
            />
            <resistor 
              name={`R${i}`} 
              resistance="330" 
              footprint="0603" 
              pcbX={x} 
              pcbY={y - 3.5} 
              pcbRotation={rotationDegrees} 
            />

            {/* Dynamically route the connections! 
                1. CD4017 Output Pin -> Resistor
                2. Resistor -> LED Positive
                3. LED Negative -> Global Ground Net
            */}
            <trace from={`.U2 > .${cd4017Outputs[i]}`} to={`.R${i} > .pin1`} />
            <trace from={`.R${i} > .pin2`} to={`.D${i} > .pos`} />
            <trace from={`.D${i} > .neg`} to="net.GND" />

          </group>
        );
      })}

    </board>
  );
}